View previous topic :: View next topic |
Author |
Message |
ecky7 Astra Enthusiast
Joined: 28 Jul 2010 Posts: 218
|
Posted: Tue Sep 28, 2010 5:16 pm Post subject: alarm wires..from engine bay to inside..easy way?? |
|
|
anyone done their amp/alarm wires from the engine bay, to inside, without making to much of a mess and not to much hardwork. any grommets??. i know the main wire bulk, that goes into the car, but dont want to go that way, if poss. cheers guys |
|
Back to top |
|
|
matt Moderator
Joined: 30 May 2005 Posts: 5212
Location: West Brom
|
Posted: Tue Sep 28, 2010 5:17 pm Post subject: |
|
|
Throttle cable route/gearshifter tunnel _________________
Aim Low, Reach Your Goals and Avoid Disappointment |
|
Back to top |
|
|
ecky7 Astra Enthusiast
Joined: 28 Jul 2010 Posts: 218
|
Posted: Tue Sep 28, 2010 5:26 pm Post subject: |
|
|
Thx Matt |
|
Back to top |
|
|
GT/Estate Astra Expert
Joined: 30 May 2005 Posts: 2230
Location: Rotherham
|
Posted: Tue Sep 28, 2010 9:53 pm Post subject: |
|
|
Under the lowest part of the heater motor there is a flat spot that is ideal for a stuffing gland this route is ideal for amp cables and is easy to drill from inside _________________ 1983 5dr project 1.4Ti in china blue
1983 SR in mat black rat on the road again
1980 5dr Opel estate (9 year ongoing project) |
|
Back to top |
|
|
ecky7 Astra Enthusiast
Joined: 28 Jul 2010 Posts: 218
|
Posted: Tue Sep 28, 2010 11:55 pm Post subject: |
|
|
Thx Gte |
|
Back to top |
|
|
DaveJ Astra Specialist
Joined: 30 May 2005 Posts: 118
Location: Bristol
|
Posted: Thu Sep 30, 2010 2:33 pm Post subject: |
|
|
I used the same route as the main wiring loom i.e. from behind the off-side suspension turret in the engine bay through to the area above the pedals - above the ECU. It was pretty easy as I recall. No drilling required. |
|
Back to top |
|
|
|